How to use Meta Glasses Charging Stand
The Meta Glasses Charging Stand provides a convenient way to charge your AI glasses when you're at home or at your desk.
Compatibility
The Meta Glasses Charging Stand is compatible with:
- Meta Adventurer
- Meta Fury
- Meta Starfire
- Oakley Meta HSTN
- Ray-Ban Meta Headliner
- Ray-Ban Meta Wayfarer
- Ray-Ban Meta Skyler
- Ray-Ban Meta Blayzer Optics
- Ray-Ban Meta Scriber Optics
The Meta Glasses Charging Stand is not compatible with:
- Oakley Meta Vanguard
- Meta Ray-Ban Display
What's in the box
- Meta Glasses Charging Stand
- Set-up guide
Note: Wall adapter and USB-C cord are not included. You can use any standard USB-C cord and wall adapter.
Set up the Meta Glasses Charging Stand
- Place the charging stand on a flat, stable surface like a desk or nightstand.
- Connect USB-C cable to the port on the charging stand.
- Plug the other end of the cable into a wall adapter or powered USB port.
- The LED on the stand will briefly light up white to confirm it's powered on.
Charge your glasses
- Close the temple arms on your glasses.
- Place the glasses onto the charging dock.
- The LED on the stand will light up to confirm charging has started.
If the LED doesn't light up when docking your glasses, try the following troubleshooting steps:
- Make sure the USB-C cable is securely connected to both the stand and a power source.
- Check that your glasses are properly seated flat on the stand with the temple arms closed.
- Undock and re-dock your glasses.
LED status indicators
The LED on the charging stand shows the current charging status:
LED color | Status |
White (solid) | Stand is powered on |
Orange (solid) | Charging in progress — battery between 20% and 95% |
Green (solid) | Charging nearly complete — battery above 95% |
Red (blinking) | Error — liquid detected or other issue (see note below) |
Note: Blinking red means liquid has been detected on the charging contacts. Remove your glasses and dry both the glasses and the stand with a soft cloth. Wait a few minutes before docking again.
Charging times
Charge level | Estimated time |
0% to 50% | 22 minutes |
0% to 100% | 75 minutes |
Note: If the charging stand isn’t charging your glasses but the LED is orange, power cycle your glasses by turning them off and then back on again. If your glasses battery is 0%, use the charging case until you can power cycle your glasses.
Firmware updates
The charging stand receives firmware updates automatically through your glasses. When an update is available:
- Dock your glasses on the stand for at least 5 minutes.
- The update will begin automatically.
- Keep your glasses on the stand until the update is complete (about 30 seconds).
If you remove your glasses during a firmware update, the LED on the stand may become unresponsive (example: the LED stays on after you remove glasses from the charging stand).
To fix an unresponsive LED, dock your glasses on the charging stand for at least 1 minute. The update will resume and complete automatically and the LED will return to normal functionality.
Care and maintenance
You can clean the charging stand with a dry microfiber cloth. If liquid is spilled on the stand, unplug the stand, dry it off and wait about 5 minutes before using it again.